MIL-DTL-3965 Capacitor, Fixed Electrolytic \(Nonsolid Electrolyte\), TantalumThis specification covers the general requirements for tantalum, electrolytic \(nonsolid electrolyte\), fixed capacitors \(polarized and nonpolarized\), hermetically and nonhermetically sealed \(see 1.2.1.7\) in metal cases; style CL67 and all tubular-foil styles are insulated \(see 6.1\). This specification also covers removable counting brackets for use with the CL55-series capacitors.

Pages 1 - - 24 - 25 - 26 - 27 - 28 - 29 - 30 - 31 - 32 - 33 - 34 - 35 - 36 - 37 - 38 - 39|||

MIL-DTL-3965H

APPENDIX A

QUALIFICATION-SUBMITTAL PLANS

A1 SCOPE

A1.1 Scope. This appendix details the qualification-submittal plans for capacitors and brackets to be subjected to

the qualification inspection specified in this specification. These plans specify the sample size, sampling criteria, and

limits of coverage for the type of qualification sought. This appendix is a mandatory part of this specification. The

information contained herein is intended for compliance.

A2 APPLICABLE DOCUMENTS

(This section is not applicable to this appendix.)

A3 SUBMITTAL PLANS

A3.1 Capacitors.

A3.1.1 Single type. The following details apply:

Sample size: As specified in table V.

Sampling criteria: Sample units of the same style, rated voltage, capacitance, capacitance tolerance, seal,

and electrolyte.

Limits of coverage: Qualification coverage will be extended to all lower capacitance values and all wider

capacitance tolerances than those in the qualified sample, but will not be extended to another style, rated

voltage, seal, or electrolyte.

A3.1.2 Voltage-group type. The following details apply:

Sample size: As specified in table XIII.

Sampling criteria: Sample units of (1) the same style, voltage group, capacitance tolerance, seal,

electrolyte, and, when applicable, case size, and (2) the highest capacitance value for the lowest rated

voltage (see NOTE) and sample units of the highest capacitance value for the highest rated voltage within a

single voltage group.

NOTE: For styles CL66 and CL67, voltage group II, low-capacitance series these sample units will be of the

highest capacitance value in the voltage group.

Limits of coverage: Qualification coverage will be extended to all intermediate (or lower) voltages in the

voltage group, all lower capacitance values, and all wider capacitance tolerances than those in the qualified

sample, but will not be extended to another style, voltage group, seal, or electrolyte.

NOTE: When a single rated voltage forms a voltage group, the single-type submittal plan applies.