MIL-PRF-49137E
6.4 Qualification. With respect to products requiring qualification, awards will be made only for products which are,
at the time of award of contract, qualified for inclusion in the Qualified Products List whether or not such products
have actually been so listed by that date. The attention of the contractors is called to these requirements, and
manufacturers are urged to arrange to have the products that they propose to offer to the Federal Government tested
for qualification in order that they may be eligible to be awarded contracts or orders for the products covered by this
specification. The activity responsible for the Qualified Products List is the U.S. Army Communications-Electronics
Command, ATTN: RDER-PRQ-QE, Aberdeen Proving Ground, MD 21015; however, information pertaining to
qualification of products may be obtained from the DLA Land and Maritime, ATTN: VQP, PO Box 3990, Columbus,
OH 43218-3990, or by e-mail to vqp.chief@dla.mil. An online listing of products qualified to this specification may be
found in the Qualified Products Database (QPD) at https://assist.dla.mil.
6.5 Verification of qualification. For the purposes of verification of qualification (see 4.5) and conformance
inspection (see 4.6), the manufacturer may use verification of qualification data from MIL-PRF-39003 provided the
internal parts are manufactured using the same process as MIL-PRF-39003.
6.6 Subject term (key word) listing.
Capacitance
Dissipation factor
Polarized
6.7 Environmentally preferable material. Environmentally preferable materials should be used to the maximum
extent possible to meet the requirements of this specification. As of the dating of this document, the U.S.
Environmental Protection Agency (EPA) is focusing efforts on reducing 31 priority chemicals. The list of chemicals is
and additional information is available on their website https://www.epa.gov/osw/hazard/wastemin/priority.htm.
Included in the list of 31 priority chemicals are cadmium, lead, and mercury. Use of these materials on the list should
be minimized or eliminated unless needed to meet the requirements specified herein (see Section 3).
6.8 Changes from previous issues. The margins of this specification are marked with vertical lines to indicate
where changes from previous issue were made. This was done as a convenience only and the Government
assumes no liability whatsoever for any inaccuracies in these notations. Bidders and contractors are cautioned to
evaluate the requirements of this document based on the entire content irrespective of the marginal notations and
relationship to the last previous issue.
17
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business