MIL-C-11272E
APPENDIX A
PROCEDURE FOR QUALIFICATION INSPECTION
A.1. SCOPE
*
A.1.1 This appendix details the procedure for submission of samples for qualification inspection of capacitors
covered by this specification. The procedure for extending qualification of the required sample to other capacitors
covered by this specification is also outlined herein. This appendix is a mandatory part of this specification. The
information contained herein is intended for compliance.
A.2. SUBMISSION
A.2.1 Sample.
*
A.2.1.1 Single style submission. A sample consisting of 51 sample units of the highest capacitance value and 13
sample units of the lowest capacitance value, but not lower than 47 pF, in each style and dc rated voltage, for which
qualification is sought shall be submitted. The sample units shall be in the J (±5 percent) or closer capacitance
tolerance. The sample units subjected to groups II and IV of table IV shall be composed of the highest capacitance
values represented in the submission, and the sample units subjected to groups III and V shall be composed of
equal numbers of the highest and lowest capacitance values represented. The sample units shall then be subjected
to the inspection for their particular group.
A.3. EXTENT OF QUALIFICATION
*
A.3.1 Single style submission. Qualification within a style and dc rated voltage will be restricted to capacitance
values within the range of values submitted. Qualification of the ±5 percent or closer capacitance tolerance
automatically qualifies all other applicable capacitance tolerances. If, where applicable, 47 pF sample units are
submitted, qualification will be granted for all capacitance values equal to and less than the highest value submitted.
19
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business