MIL-PRF-11693 Capacitors, Feed Through, Radio-Interference Reduction, Dc \(Hermetically Sealed In Metal Cases\), Established And Non-Established Reliability General Specification ForThis specification covers the general requirements for established reliability \(ER\) and non-ER capacitors designed for operation with direct current \(dc\), paper, paper plastic, and plastic \(extended foil\) dielectric, radio-interference-reduction, feed-through capacitors, hermetically sealed in metal cases \(see 6.6.2\), for use primarily in broadband, radio-interference suppression application. Capacitors meeting the established reliability requirements specified herein have a maximum failure rate of 1.0 percent per 1,000 hours. This failure rate is established with a 90-percent confidence limit based on the life test parameters specified and are maintained at a 10-percent producer?╞s risk. An acceleration factor of 5:1 has been used to relate the life test data obtained at 140 percent of rated dc voltage at the applicable high test temperature to the rated voltage at the applicable high test temperature.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7 - 8 - 9 - 10 - 11 - 12 - 13 - 14 - 15 - 16

MIL-PRF-11693E

2.2 Government documents.

2.2.1 Specifications. standards. and handbooks. The following specifications, standards, and handbooks form a

part of this document to the extent specified herein. Unless otherwise specified, the issues of these documents are

those cited in the solicitation or contract (See 6.2).

FEDERAL STANDARDS

Screw-Thread Standards for Federal Services.

DEPARTMENT OF DEFENSE SPECIFICATIONS

Capacitors, Feed Through, Radio-Interference Reduction, DC (Hermetically

Sealed in Metal Cases), Established and Non-Established Reliability, Styles

CZ23, CZ24, CZR23 and CZR24.

DEPARTMENT OF DEFENSE STANDARDS

Test Method Standard Electronic and Electrical Component Parts.

Method of Insertion Loss Measurement.

Failure Rate Sampling Plans and Procedures.

Established Reliability and High Reliability Qualified Products List (QPL) Systems

for Electrical, Electronic, and Fiber Optic Parts Specifications.

Marking of Electrical and Electronic Parts.

(Copies of these documents are available online at https://assist.dla.mil/quicksearch/ or from the Standardization

Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)

2.3 Non-Government publications. The following documents form a part of this document to the extent specified

herein. Unless otherwise specified, the issues of the documents are those listed in the solicitation or contract.

ASTM INTERNATIONAL (ASTM)

Standard Test Method for Flash and Fire Points by Cleveland Open Cup Tester.

(Copies of this document are available online at www.astm.org or from ASTM International, 100 Barr Harbor Drive,

West Conshohocken, PA 19428-2959.)

INTERNATIONAL ORGANIZATION FOR STANDARDIZATION (ISO)

Measurement Management Systems - Requirements for Measurement Processes

and Measuring Equipment.

(Copies of this document are available online at www.iso.org or from the International Organization for

Standardization, 1, ch. de la Voie-Creuse, Case postale 56, CH-1211 Geneva 20, Switzerland.)

NATIONAL CONFERENCE OF STANDARDS LABORATRIES (NCSL)

Requirements for the Calibration of Measuring and Test Equipment.

(Copies of this document are available online at www.ncsli.org or from NCSL International, 1800 30th Street, Suite

305, Boulder, CO 80701-1026.)