MIL-PRF-55365/7B
NOTES:
1. Dimensions are in inches.
2. Metric equivalents are given for general information only.
3. These capacitors are designed for mounting by dip soldering, vapor phase, reflow soldering, or
other conventional means.
4. These capacitors will have a minimum of two bonding pads (top and bottom), on the major (width)
dimension.
5. The anode termination (dimension D minus dimension B) shall be .010 inch (0.25 mm) minimum.
FIGURE 1. Style CWR10 (conformally coated) capacitors - Continued.
REQUIREMENTS:
Dimensions and configuration: See figure 1.
Termination finish: In accordance with MIL-PRF-55365.
DC rated voltage: See table I. Above +85°C, voltage derating is required (see MIL-PRF-55365).
Operating temperature range: -55°C to +125°C.
Product level designator: In accordance with MIL-PRF-55365.
DC leakage (DCL): See table I.
Capacitance (Cap.): See table I.
Cap. tolerance: ±5 percent (J), ±10 percent (K), or ±20 percent (M).
Dissipation factor (DF): See table I.
Equivalent series resistance (ESR) at 100 kHz: In accordance with MIL-PRF-55365 (see table I).
Resistance to soldering heat: In accordance with MIL-PRF-55365.
Stability at low and high temperatures: In accordance with MIL-PRF-55365.
Step 1 (+25°C):
DCL
-
See table I.
Cap.
-
Shall not exceed tolerance of table I value.
DF
-
See table I.
ESR
-
See table I.
ĆCap. -
Step 2 (-55°C):
Shall not exceed ±10 percent of initial measurement.
DF -
See table I.
Step 3 (+25°C):
DCL -
See table I.
ĆCap. -
Shall not exceed ±5 percent of initial +25°C measurement.
DF -
See table I.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business