MIL-PRF-55514/8G
REQUIREMENTS:
Design and construction:
Dimensions and configuration: See figure 1 and table I.
Case type: Molded or preformed.
Capacitance tolerance: See table I.
*
Operating temperature range: -55°C to +85°C. Will operate to +125°C when properly derated to 50 percent of
+85°C rated voltage.
*
Characteristic: R or U.
Voltage rating: See table I.
Dissipation factor: Not more than 0.3 percent.
Preconditioning: Not applicable.
Burn-in: DC: 48 hours at 125°C, at 1.4 times the derated 125°C voltage rating. The current to each capacitor
shall be limited to 1 ampere maximum by a series resistor.
AC: Not applicable.
Dielectric withstanding voltage: 200 percent of rated voltage for 10 seconds to 60 seconds. The surge current
shall be limited to 1 ampere, maximum.
Resistance to soldering heat: In accordance with MIL-PRF-55514 except that spacers or standoffs of .25 inch
(6.4 mm) are required.
Application note: These capacitors are heat sensitive. Vapor phase soldering is not recommended. For
applications that require wave soldering that exceeds a 5 second duration, it is recommended that a spacer or
standoff be used.
Marking: In accordance with MIL-PRF-55514 except that minimum marking as shown in the following example will
be permitted. Location of manufacturer's code or symbol is optional. Full marking shall be included on the
package.
Front
Reverse side
Type designation
J = JAN, and two digit
CFR12
manufacturer's code or symbol.
J--
RRA
Date code in accordance with
0211
333 FM
MIL-PRF-55514.
3